Replace the ceiling light bulb of an Iveco Minicab is a super repair simple to execute . No need to be an excellent mechanic, it requires basic tools and no mechanical knowledge. To make this replacement, count about 10 minutes . However, before starting the work, you must ensure that the problem must come from the bulb. We will discover first how to know where the problem should come from, then how to change the defective bulb.change-bulb-ceiling-Iveco-Minicab

The ceiling bulb of your Iveco Minicab does not work any more: the different causes.

The bulb is defective . This is of course the most common reason. Whatever happens, you will need to remove the light unit from your Iveco Minicab. To do this, follow the steps in the next paragraph. To control it it's super simple. If it is ever a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, it will be necessary to check that the current flows properly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical concern . It is less common, however it can still happen on an Iveco Minicab. It happens that there is a short-juice, or that a connector is dirty. In this case, check the voltage at both ends. If the current does not pass properly, the wiring must be followed until the origin of the fault is perceived. It also happens that the connectors are dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the light bulb on your Iveco Minicab

Now that you have found the cause of the failure, you are certain that the problem must come from the bulb. Let's see how to change the ceiling light bulb step by step on an Iveco Minicab.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it with the new one. It is of course necessary that the size and the base are identical
  • Place the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. And now, voila ! The ceiling lamp of your Iveco Minicab should work normally. Good walk.