Changing the bulb of the ceiling light of a Jeep Cj7 is an extremely repair simple to execute . There is no need to be a great mechanic, it requires few tools and no knowledge of mechanics. To perform this operation, plan ten minutes . But before you start the work, it is necessary to make sure that the problem comes from the bulb. We will first find out how to find out where the problem comes from, then how to change the burnt out bulb.change-bulb-ceiling-Jeep-Cj7

The ceiling light of your Jeep Cj7 no longer works: various reasons.

The bulb is defective . This is naturally the most common cause. Whatever happens, you will have to remove the light unit from the Jeep Cj7. To do this, it is necessary to follow the steps in the next paragraph. To check it is extremely simple. If it's a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, it is necessary to check that the electricity is circulating correctly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical concern . It's less common, but it can still happen on a Jeep Cj7. It happens that there is a short circuit, or a connector is dirty. In this case, examine the voltage at both poles. If the electricity does not pass correctly, it will be necessary to follow the wiring until the origin of the fault is found. It also happens that the connectors are dirty. In this case, you will have to clean them using a specialized product and measure the voltage again.

How to replace the ceiling bulb of your Jeep Cj7

Once you have found the source of the fault, you are sure the problem is with the bulb. We will see how to change the bulb of the ceiling light step by step on a Jeep Cj7.

  • Remove the ceiling lamp with a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must be identical
  • Install the new bulb carefully
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling light bulb of your Jeep Cj7 should work normally. Enjoy the road.