Changing the light bulb of a Jeep Comanche ceiling light is a very operation easy to perform . Useless to be a great handyman, this repair requires few tools and no notions in mechanics. To carry out this operation, plan ten minutes . However before you start repairing, you will need to make sure that the problem comes from the bulb. We will first find out how to find out where the problem is coming from, then how to change the faulty bulb.
The ceiling bulb of your Jeep Comanche does not work anymore: the different reasons.
The bulb is defective . This is of course the most common cause. Whatever happens, you're going to have to remove the light block from the Jeep Comanche. To do this, you will have to follow the steps in the next section. To verify it is very easy. In case it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, you will have to check that the electricity flows correctly using a voltmeter. Try to take the voltage on both sides of the connector. An electrical problem . It's less common, but it can still happen on a Jeep Comanche. It happens that there is a short-juice, or that a connector is dirty. In this situation, inspect the tension at both poles. In the event that the electricity does not pass correctly, the electric wires must be followed until the source of the fault is found. It also happens that the connectors are dirty. So, we will have to clean them with a specialized product and measure the tension again.
How to replace the light bulb on your Jeep Comanche
Once you have found the source of the failure, you are sure that the problem is with the bulb. We will see how to change the bulb of the ceiling light point by point on a Jeep Comanche.
- Remove the ceiling lamp with a flat screwdriver. Pass it in the groove to make a lever.
- Disconnect the connector
- Dismount the ceiling light so as to have access to the bulb
- Remove the bulb and compare it to the new one. Of course, the size and the base must match
- Install the new bulb carefully
- Replace the connectors and the dome following the reverse procedure
You can now turn on the ignition and check that the bulb is working properly. It's good, it's done! The ceiling bulb of your Jeep Comanche should work normally. Enjoy the road.