Changing the light bulb on a Jeep Commander is a very manipulation simple to make . No need to be an excellent mechanic, this repair requires basic tools and no mechanical knowledge. To do this, plan about 10 minutes . However before embarking on repairs, it is necessary to make sure that the problem comes from the bulb. We will first see how to find out where the problem comes from, then how to replace the damaged bulb.change-bulb-ceiling-Jeep-Commander

The ceiling bulb of your Jeep Commander does not work anymore: the different origins.

The bulb is defective . This is of course the most common reason. In all cases, you will have to remove the light unit from your Jeep Commander. To do this, it is necessary to follow the steps in the next part. To verify it is very simple. If it is a filament bulb, you can visually check that the filament is broken. If however it is an LED bulb, it is necessary to check that the current flows properly by using a voltmeter. Try to take the voltage on both sides of the connector. An electrical concern . It is less frequent, however it can still happen on a Jeep Commander. It is possible that there is a short-juice, or that a connector is dirty. In this case, inspect the tension at both poles. If the current does not pass properly, you must follow the electric wires until you see the cause of the failure. It is also possible that the connectors are dirty. So, we will have to clean them using a specialized product and measure the voltage.

How to replace the light bulb on your Jeep Commander

Now that you have found the cause of the failure, you are certain that the problem comes from the bulb. Let's see how to replace the light bulb point by point on a Jeep Commander.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light in order to have access to the bulb
  • Remove the bulb and compare it to the new one. It is of course necessary that the dimensions and the base correspond
  • Attach the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. It's good, voila! The ceiling light bulb on your Jeep Commander should work normally. Good walk.