Changing the bulb in the ceiling light of a Jeep Wagoneer is an extremely manipulation easy to execute . No need to be an excellent handyman, it requires basic tools and no knowledge of mechanics. To carry out this replacement, plan about 10 minutes . However, before starting the work, you will have to make sure that the problem is with the bulb. We will first see how to find out where the problem came from, then how to change the faulty bulb.
The bulb in the ceiling light of your Jeep Wagoneer has stopped working: various causes.
The bulb is defective . This is of course the most common cause. Whatever happens, you will have to remove the light unit from your Jeep Wagoneer. In order to do this, you will have to follow the steps in the next part. To verify it is extremely easy. If it's a filament bulb, you can visually check that its filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates correctly thanks to a voltmeter. Try to take the voltage on both sides of the connector. An electrical problem . It is less common, however it can still happen on a Jeep Wagoneer. It happens that there is a bad contact, or that a connector is dirty. In this case, inspect the voltage at both poles. If the electricity is not flowing properly, you must follow the electrical wires until you find the cause of the failure. It also happens that the connectors are dirty. Then, you will have to clean them using a specialized product and measure the voltage again.
How to replace the ceiling bulb of your Jeep Wagoneer
Once you find the cause of the failure, you are sure the problem is with the bulb. We will see how to change the bulb of the ceiling light point by point on a Jeep Wagoneer.
- Remove the ceiling lamp with a flat screwdriver. Insert it into the groove to pry.
- Remove the connector
- Disassemble the ceiling light so as to have access to the bulb
- Remove the bulb and compare it with the new one. It is of course necessary that the dimensions and the base correspond
- Carefully place the new bulb
- Reposition the connectors and the ceiling light in the opposite direction
You can now switch on the ignition and check that the bulb is working properly. And voila, it's done! The bulb in the ceiling light of your Jeep Wagoneer will work normally. Good walk.