Replace the bulb of the ceiling lamp of a Kia Clarus is a very manipulation easy to execute . There is no need to be an excellent handyman, this repair requires basic tools and no knowledge of mechanics. To make this replacement, count ten minutes . But before you start the work, you will have to make sure that the problem must come from the bulb. We will see at first how to know where the problem should come from, then how to change the damaged bulb.change-bulb-ceiling-light-Kia-Clarus

The ceiling bulb of your Kia Clarus does not work anymore: the different causes.

The bulb is defective . This is of course the most common reason. Whatever happens, you're going to have to remove the light block from the Kia Clarus. In order to do this, you will need to follow the steps in the next paragraph. To verify it is very easy. If it is a filament bulb, you can visually check that its filament is broken. If on the other hand it is an LED bulb, you will have to check that the electricity circulates correctly thanks to a voltmeter. Try to measure the voltage on both sides of the connector. An electrical concern . It's less ordinary, however it can still happen on this Kia Clarus. There may be a false contact, or a connector may be dirty. In this case, inspect the voltage at both ends. If the electricity does not pass correctly, you must follow the electric cables until you find the cause of the failure. The connectors may also be dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the light bulb on your Kia Clarus

Now that you have found the cause of the failure, you are sure that the problem must come from the bulb. We will see how to change the ceiling light bulb point by point on this Kia Clarus.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the size and the base must match
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling lamp of your Kia Clarus will operate normally. Good walk.