Replace the bulb of the ceiling lamp of a Kia Provo is a super manipulation easy to perform . There is no need to be an excellent mechanic, it requires few tools and no mechanical knowledge. To perform this operation, count ten minutes . However before going into repairs, you will have to make sure that the malfunction comes from the bulb. We will first see how to find out where the malfunction comes from, then how to change the defective bulb.change-bulb-ceiling-light-Kia-Provo

The ceiling lighting of your Kia Provo does not work any more: the different reasons.

The bulb is defective . This is of course the most common cause. Whatever happens, you will need to remove the light unit from the Kia Provo. To do this, you will have to follow the steps in the next paragraph. To control it is super easy. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, you will have to check that the electricity circulates correctly thanks to a voltmeter. Try to measure the voltage on both sides of the connector. An electrical malfunction . It is less frequent, however it can still happen on a Kia Provo. There may be a short juice, or a connector may be dirty. In this situation, check the voltage at both ends. In the event that the electricity does not pass correctly, the wiring must be followed until the source of the fault is found. The connectors may also be dirty. In this case, you will have to clean them using a specialized product and measure the voltage.

How to replace the light bulb on your Kia Provo

Now that you have found the source of the fault, you are sure that the fault comes from the bulb. We will see how to change the ceiling light bulb step by step on a Kia Provo.

  • Remove the ceiling light using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Attach the new bulb gently
  • Reposition the connectors and the ceiling light in the opposite direction

You can now turn on the ignition and check that the bulb is working properly. And now, voila ! The ceiling bulb of your Kia Provo should work normally. Good road.