Changing the light bulb of a Mazda Sassou ceiling light is an extremely simple to make . No need to be a great handyman, it requires few tools and no knowledge of mechanics. To make this replacement, count ten minutes . However before starting the work, you will have to make sure that the problem comes from the bulb. We will first find out how to find out where the problem is coming from, and then how to replace the faulty bulb.change-bulb-ceiling-Mazda-Sassou

The bulb of the ceiling light of your Mazda Sassou does not work anymore: the different origins.

The bulb is defective . This is obviously the most common reason. Whatever happens, you will have to dismantle the lighting unit of the Mazda Sassou. To do this, you will have to follow the steps in the next part. To control it is extremely simple. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical problem . It's less ordinary, however it can still happen on a Mazda Sassou. It happens that there is a short circuit, or that a connector is dirty. In this case, check the voltage at the two poles. In the event that the electricity does not pass properly, the wiring must be followed until the cause of the fault is found. It also happens that the connectors are dirty. In this case, you will have to clean them using a specialized product and measure the voltage.

How to replace the light bulb on your Mazda Sassou

Once you find the cause of the failure, you can be sure that the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on a Mazda Sassou.

  • Remove the ceiling light using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must match
  • Carefully place the new bulb
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. It's good, voila! The ceiling bulb of your Mazda Sassou should work normally. Enjoy the road.