Replacing the headlight bulb of a Renault Grand Scenic 3 is an extremely manipulation simple to perform . No need to be a great handyman, it requires basic tools and no knowledge of mechanics. To perform this operation, count ten minutes . However, before you start the repairs, you will have to make sure that the problem comes from the bulb. We will first of all see how to know where the problem comes from, then how to replace the burnt out bulb.change-bulb-ceiling-light-Renault-Grand-Scenic-3

The bulb in the ceiling light of your Renault Grand Scenic 3 no longer works: the different origins.

The bulb is defective . This is of course the most common cause. In all cases, you will have to remove the lighting unit from your Renault Grand Scenic 3. In order to do this, you will have to follow the steps in the following paragraph. To check it is extremely simple. In case it is a filament bulb, you can visually check that this filament is broken. If, on the other hand, it is an LED bulb, it will be necessary to check that the electricity is circulating correctly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical concern . This is less common, however it can still happen on a Renault Grand Scenic 3. It is possible that there is a bad contact, or that a connector is dirty. In this situation, check the tension at both ends. In the event that the electricity does not pass correctly, you will have to follow the electrical cables until you perceive the source of the failure. It is also possible that the connectors are dirty. In this case, you will have to clean them with a specialized product and re-measure the voltage.

How to replace the light bulb on your Renault Grand Scenic 3

Now that you have found the source of the failure, you are sure that the problem comes from the bulb. We will see how to replace the ceiling light bulb step by step on a Renault Grand Scenic 3.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must correspond
  • Place the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. And now, voila ! The ceiling bulb of your Renault Grand Scenic 3 should work normally. Good road.