Changing the light bulb in a Seat 124 is an extremely manipulation simple to perform . You don't have to be an excellent mechanic, it requires few tools and no mechanical knowledge. To perform this operation, count ten minutes . But before you jump into any repairs, you're going to need to make sure the bulb should be the problem. We will first see how to find out where the problem must be, and then how to replace the burnt out bulb.change-bulb-ceiling-lamp-Seat-124

The ceiling light of your Seat 124 no longer works: various reasons.

The bulb is defective . This is of course the most frequent reason. Whatever happens, you will have to remove the light unit from the Seat 124. To do this, you will have to follow the steps in the next paragraph. To control it is extremely simple. In case it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, you will have to check that the current is flowing correctly using a voltmeter. Try to measure the voltage on the two connector poles. An electrical problem . This is less common, but it can still happen on a Seat 124. It is possible that there is a short-juice, or that a connector is dirty. In this case, examine the voltage at both poles. In the event that the current does not pass correctly, you will have to follow the electrical wires until you see the origin of the failure. It is also possible that the connectors are dirty. In this case, you will have to clean them with a specialized product and measure the tension again.

How to replace the ceiling light bulb on your Seat 124

Now that you have found the source of the fault, you are sure the problem must be with the bulb. We will see how to replace the ceiling light bulb step by step on a Seat 124.

  • Remove the ceiling light with a flat screwdriver. Pass it in the groove to leverage.
  • Disconnect the connector
  • Disassemble the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. It is of course necessary that the dimensions and the base correspond
  • Place the new bulb carefully
  • Reposition the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. And voila, it's done! The bulb in the ceiling light of your Seat 124 should work normally. Good walk.