Changing the light bulb in a Seat 127 is a very manipulation simple to execute . No need to be a great mechanic, it requires few tools and no knowledge of mechanics. To carry out this operation, plan ten minutes . However before you start repairing, you will have to make sure that the problem must come from the bulb. We will see first of all how to know where the problem should come from, then how to change the damaged bulb.change-bulb-ceiling-lamp-Seat-127

The lighting of the ceiling lamp of your Seat 127 does not work anymore: the different origins.

The bulb is defective . This is of course the most common cause. Whatever happens, you will have to remove the lighting unit from the Seat 127. For that, you will have to follow the steps in the next part. To verify it is very simple. In case it is a filament bulb, you can visually check that this filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical concern . It is less common, however it can still happen on a Seat 127. It happens that there is a false contact, or that a connector is dirty. In this case, check the voltage at the two poles. In the event that the electricity does not pass properly, you will have to follow the electric wires until you perceive the cause of the failure. It also happens that the connectors are dirty. So, we will have to clean them with a specialized product and measure the voltage again.

How to replace the ceiling light bulb on your Seat 127

Now that you have found the cause of the failure, you are certain that the problem must come from the bulb. We will see how to change the bulb of the ceiling light point by point on a Seat 127.

  • Remove the ceiling light with a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. It is of course necessary that the size and the base are identical
  • Place the new bulb gently
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The bulb of the ceiling lamp of your Seat 127 will operate normally. Good walk.