Replacing the headlight bulb of a Seat 132 is a super operation easy to make . There is no need to be an excellent handyman, it requires few tools and no knowledge of mechanics. To make this replacement, count ten minutes . However, before you start repairs, you will need to make sure that the problem is with the bulb. We will first see how to find out where the problem is, and then how to replace the failing bulb.change-bulb-ceiling-lamp-Seat-132

The ceiling lighting of your Seat 132 no longer works: the various origins.

The bulb is defective . This is naturally the most common cause. In any case, you will have to remove the light unit from the Seat 132. To do this, you will have to follow the steps in the next paragraph. To control it is super easy. When it is a filament bulb, you can visually check that this filament is broken. When on the other hand it is an LED bulb, it will be necessary to check that the current flows properly thanks to a voltmeter. Try to take the tension on both sides of the connector. An electrical problem . It is less common, but it can still happen on this Seat 132. It is possible that there is a short circuit, or that a connector is dirty. In this case, examine the tension at both ends. When the current does not pass properly, it will be necessary to follow the electric wires until the origin of the failure is found. It is also possible that the connectors are dirty. So, we will have to clean them using a specialized product and re-measure the voltage.

How to replace the ceiling light bulb on your Seat 132

Now that you have found the cause of the failure, you are certain that the problem originated from the bulb. Let's see how to replace the ceiling light bulb point by point on this Seat 132.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it with the new one. Naturally, the dimensions and the base must correspond
  • Install the new bulb carefully
  • Reposition the connectors and the ceiling light in the other direction

You can now switch on the ignition and check that the bulb is working properly. And now, voila ! The ceiling bulb of your Seat 132 should work normally. Good road.