Changing the light bulb in a Seat 133 is a very repair simple to make . No need to be an excellent handyman, this repair requires few tools and no knowledge of mechanics. To make this replacement, plan ten minutes . However, before starting the work, you will have to make sure that the problem comes from the bulb. We will first see how to find out where the problem is coming from, then how to replace the damaged bulb.change-bulb-ceiling-lamp-Seat-133

The lighting of the ceiling lamp of your Seat 133 does not work anymore: the different origins.

The bulb is defective . This is of course the most common cause. In all cases, you will have to remove the lighting unit from your Seat 133. To do so, you will have to follow the steps in the next part. To check it is very simple. If it's a filament bulb, you can visually check that this filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the electricity is circulating properly using a voltmeter. Remember to measure the voltage on the two poles of the connector. An electrical problem . It is less ordinary, however it can still happen on a Seat 133. It is possible that there is a bad contact, or that a connector is dirty. In this situation, examine the voltage at both poles. If the electricity does not pass properly, you will have to follow the electrical wires until you find the source of the fault. It is also possible that the connectors are dirty. In this case, you will have to clean them using a specialized product and re-measure the voltage.

How to replace the ceiling light bulb on your Seat 133

Now that you have found the source of the failure, you are sure that the problem is with the bulb. Let's see how to replace the light bulb step by step on a Seat 133.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Disconnect the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. It is of course necessary that the dimensions and the base are identical
  • Place the new bulb carefully
  • Replace the connectors and the ceiling light in reverse order

You can now switch on the ignition and check that the bulb is working properly. It's good, you're done! The ceiling bulb of your Seat 133 should work normally. Good road.