Replacing the headlight bulb of a Seat 600 is a super repair easy to make . No need to be a great handyman, it requires few tools and no knowledge of mechanics. To make this replacement, plan about 10 minutes . But before you jump into any repairs, you're going to need to make sure the problem is with the bulb. We will first see how to know where the problem comes from, then how to replace the faulty bulb.change-bulb-ceiling-lamp-Seat-600

The ceiling lighting of your Seat 600 no longer works: the various origins.

The bulb is defective . This is of course the most common cause. In any case, you will have to remove the light unit from the Seat 600. To do so, you will have to follow the steps in the next part. To check it is super easy. If it's a filament bulb, you can visually check that this filament is broken. If on the other hand it is an LED bulb, you will have to check that the electricity is circulating properly using a voltmeter. Try to measure the voltage on the two connector poles. An electrical problem . It is less ordinary, however it can still happen on a Seat 600. It happens that there is a short circuit, or a connector is dirty. In this situation, check the tension at both ends. If the electricity does not pass properly, you must follow the electric cables until you see the source of the failure. It also happens that the connectors are dirty. In this case, it will be necessary to clean them using a specialized product and to re-measure the tension.

How to replace the ceiling light bulb on your Seat 600

Now that you have found the cause of the failure, you are sure that the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on a Seat 600.

  • Remove the ceiling lamp using a flat screwdriver. Introduce it into the groove to make a lever.
  • Disconnect the connector
  • Disassemble the ceiling light to have access to the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Attach the new bulb carefully
  • Reposition the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling bulb of your Seat 600 should work normally. Good walk.