Replace the light bulb in a seat exeo is a super manipulation simple to make . No need to be a great mechanic, it requires few tools and no knowledge of mechanics. To do this, count about 10 minutes . But before you go into repairs, you will need to make sure that the problem comes from the bulb. We will first find out how to find out where the problem is coming from, then how to change the damaged bulb.
The bulb of the ceiling light of your seat exeo does not work anymore: the different causes.
The bulb is defective . This is of course the most common reason. Whatever happens, you will have to remove the lighting unit from the seat exeo. To do this, you will have to follow the steps in the next paragraph. To check it is super simple. When it is a filament bulb, you can visually check that the filament is broken. When, on the other hand, it is an LED bulb, you will have to check that the current flows properly thanks to a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical concern . It is less frequent, however it can still happen on a seat exeo. It happens that there is a short circuit, or that a connector is dirty. In this situation, check the voltage at both ends. When the current does not pass properly, the wiring must be followed until the cause of the fault is perceived. It also happens that the connectors are dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.
How to replace the light bulb in your seat exeo
Now that you have found the cause of the failure, you can be sure that the problem is with the bulb. We will see how to change the ceiling light bulb step by step on a seat exeo.
- Remove the ceiling light with a flat screwdriver. Introduce it into the groove to make a lever.
- Remove the connector
- Dismount the ceiling lamp in order to access the bulb
- Remove the bulb and compare it to the new one. Of course, the size and the base must match
- Attach the new bulb gently
- Replace the connectors and the dome following the reverse procedure
You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The light bulb in your seat exeo should work normally. Enjoy the road.