Replacing the light bulb in a Seat Fura is a super operation simple to perform . No need to be an excellent mechanic, it requires basic tools and no mechanical knowledge. To make this replacement, count ten minutes . But before you start repairing, you will have to make sure that the malfunction comes from the bulb. We will first see how to know where the malfunction is coming from, then how to change the faulty bulb.change-bulb-ceiling-lamp-Seat-Fura

The ceiling light bulb in your Seat Fura does not work anymore: the different reasons.

The bulb is defective . This is obviously the most common cause. Whatever happens, you will need to remove the light block from the Seat Fura. To do this, you will need to follow the steps in the next section. To control it it's super simple. In case it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, you will have to check that the electricity is flowing correctly thanks to a voltmeter. Remember to take the voltage on the two poles of the connector. An electrical malfunction . It's less ordinary, however it can still happen on a Seat Fura. There may be a short circuit, or a connector may be dirty. In this situation, examine the voltage at the two poles. If the electricity does not pass correctly, you must follow the electric cables until you find the source of the fault. The connectors may also be dirty. Then, it will be necessary to clean them with a specialized product and to measure the voltage.

How to replace the light bulb on your Seat Fura

Now that you have found the source of the failure, you are certain that the malfunction comes from the bulb. Let's see how to change the ceiling light bulb step by step on a Seat Fura.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Disconnect the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must match
  • Attach the new bulb carefully
  • Reposition the connectors and the ceiling light in the opposite direction

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The bulb of the ceiling lamp of your Seat Fura will operate normally. Good walk.