Changing the ceiling light bulb on a Suzuki Alto is an extremely manipulation simple to execute . No need to be a great mechanic, this repair requires few tools and no mechanical knowledge. To carry out this replacement, plan about 10 minutes . However before starting the repairs, it is necessary to make sure that the problem must come from the bulb. We will see first of all how to know where the problem should come from, then how to change the faulty bulb.
The ceiling bulb of your Suzuki Alto does not work anymore: the different causes.
The bulb is defective . This is obviously the most common reason. In all cases, you will have to remove the lighting unit from your Suzuki Alto. To do this, it is necessary to follow the steps in the next paragraph. To verify it is extremely simple. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, it is necessary to check that the current flows correctly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical concern . It's less ordinary, however it can still happen on this Suzuki Alto. There may be a short juice, or a connector may be dirty. In this situation, examine the voltage at the two poles. In the event that the current does not flow correctly, the electrical wires must be followed until the cause of the fault is perceived. The connectors may also be dirty. In this case, it will be necessary to clean them using a specialized product and measure the tension.
How to replace the ceiling light bulb on your Suzuki Alto
Now that you have found the cause of the failure, you are certain that the problem must come from the bulb. Let's see how to change the light bulb step by step on this Suzuki Alto.
- Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to make a lever.
- Disconnect the connector
- Dismount the ceiling light so as to have access to the bulb
- Remove the bulb and compare it with the new one. Obviously, the dimensions and the base must be identical
- Place the new bulb gently
- Reposition the connectors and the ceiling light in the opposite direction
You can now switch on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling bulb of your Suzuki Alto will work normally. Good walk.