Changing the light bulb of a Suzuki Baleno 2 is a super repair simple to perform . There is no need to be a great handyman, this repair requires few tools and no knowledge of mechanics. To make this replacement, plan about 10 minutes . However before starting the repairs, you will have to make sure that the problem comes from the bulb. We will see first of all how to know where the problem comes from, then how to replace the burnt out bulb.change-light-bulb-ceiling-Suzuki-Baleno-2

The overhead lighting on your Suzuki Baleno 2 no longer works: the different causes.

The bulb is defective . This is of course the most common cause. In all cases, you will need to remove the light block from the Suzuki Baleno 2. To do this, you will have to follow the steps in the next paragraph. To control it it's super simple. If it is a filament bulb, you can visually check that the filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates correctly using a voltmeter. Try to take the voltage on both sides of the connector. An electrical concern . It is less common, however it can still happen on this Suzuki Baleno 2. It is possible that there is a short-juice, or that a connector is dirty. In this case, check the tension at both ends. If the electricity does not pass correctly, it will be necessary to follow the wiring until you see the cause of the failure. It is also possible that the connectors are dirty. So, you will have to clean them with a specialized product and measure the voltage again.

How to replace the ceiling lamp on your Suzuki Baleno 2

Now that you have found the cause of the failure, you are sure that the problem comes from the bulb. We will see how to replace the ceiling light bulb point by point on this Suzuki Baleno 2.

  • Remove the ceiling lamp with a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light in order to have access to the bulb
  • Remove the bulb and compare it to the new one. Naturally, the size and the base must match
  • Install the new bulb carefully
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb works properly. And voila, it's done! The ceiling bulb of your Suzuki Baleno 2 should work normally. Good road.