Changing the bulb of the ceiling light of a Suzuki Ignis 2 is a very manipulation simple to make . No need to be an excellent handyman, this repair requires few tools and no knowledge of mechanics. To perform this replacement, count ten minutes . However, before you start the work, you will have to make sure that the problem is with the bulb. We will first find out how to find out where the problem is coming from, and then how to replace the faulty bulb.change-light-bulb-ceiling-Suzuki-Ignis-2

The ceiling lighting of your Suzuki Ignis 2 no longer works: various causes.

The bulb is defective . This is of course the most common cause. In any case, you will have to remove the lighting unit from the Suzuki Ignis 2. For this, you will have to follow the steps in the next part. To check it is very simple. When it is a filament bulb, you can visually check that its filament is broken. When on the other hand it is an LED bulb, you will have to check that the electricity is circulating correctly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical problem . It is less common, however it can still happen on this Suzuki Ignis 2. There may be a short circuit, or a connector may be dirty. In this situation, examine the voltage at both poles. When the electricity does not pass properly, you must follow the wiring until you find the source of the fault. The connectors may also be dirty. So, we will have to clean them with a specialized product and measure the voltage again.

How to replace the ceiling bulb of your Suzuki Ignis 2

Now that you have found the source of the failure, you are sure that the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on this Suzuki Ignis 2.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Place the new bulb carefully
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling bulb of your Suzuki Ignis 2 must work normally. Good road.