Replacing the light bulb in a Suzuki Kizashi is an extremely manipulation simple to make . There is no need to be a great handyman, it requires basic tools and no mechanical knowledge. To carry out this operation, plan ten minutes . However before starting the repairs, you will need to make sure that the problem comes from the bulb. We will see at first how to know where the problem comes from, then how to replace the damaged bulb.change-bulb-ceiling-maker-Suzuki-Kizashi

The ceiling lighting of your Suzuki Kizashi does not work anymore: the different reasons.

The bulb is defective . This is obviously the most common cause. In any case, you will have to dismantle the lighting unit of the Suzuki Kizashi. To do this, follow the steps in the next paragraph. To control it is extremely simple. If it is ever a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, it will be necessary to check that the electricity is circulating properly using a voltmeter. Try to take the voltage on both sides of the connector. An electrical concern . It's less common, but it can still happen on a Suzuki Kizashi. It is possible that there is a false contact, or that a connector is dirty. In this case, check the voltage at both ends. If the electricity does not pass properly, you will have to follow the electric cables until you find the source of the failure. It is also possible that the connectors are dirty. Then, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the ceiling light bulb on your Suzuki Kizashi

Now that you have found the source of the failure, you can be sure that the problem is with the bulb. We will see how to replace the ceiling light bulb point by point on a Suzuki Kizashi.

  • Remove the ceiling lamp with a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Dismount the ceiling lamp in order to access the bulb
  • Remove the bulb and compare it with the new one. Obviously, the size and the base must match
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb works properly. It's good, voila! The ceiling bulb of your Suzuki Kizashi should work normally. Good road.