Changing the light bulb in a Suzuki Swift is a super manipulation simple to make . No need to be an excellent handyman, it requires few tools and no mechanical knowledge. To make this replacement, count about 10 minutes . However before starting the repairs, you will have to make sure that the problem must come from the bulb. We will see first how to know where the problem must come from, then how to replace the damaged bulb.change-bulb-ceiling-Suzuki-Swift

The overhead lighting of your Suzuki Swift does not work anymore: the different causes.

The bulb is defective . This is of course the most common cause. Whatever happens, you're going to have to remove the light block from the Suzuki Swift. To do this, you will have to follow the steps in the following paragraph. To check it is super simple. If it is a filament bulb, you can visually check that its filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the current flows correctly thanks to a voltmeter. Try to measure the voltage on the two poles of the connector. An electrical problem . It's less ordinary, but it can still happen on this Suzuki Swift. It is possible that there is a short circuit, or that a connector is dirty. In this case, inspect the tension at both ends. If the current does not flow correctly, you must follow the electric cables until you perceive the source of the failure. It is also possible that the connectors are dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension.

How to replace the ceiling light bulb on your Suzuki Swift

Now that you have found the source of the fault, you are certain that the problem must come from the bulb. We will see how to replace the ceiling light bulb step by step on this Suzuki Swift.

  • Remove the ceiling light with a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Dismount the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it with the new one. Of course, the size and the base must be identical
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb works properly. It's good, it's done! The ceiling lamp of your Suzuki Swift should work normally. Good walk.