Changing the bulb of the ceiling light of a Suzuki Sx4 is a very repair easy to perform . No need to be a great handyman, this repair requires few tools and no mechanical knowledge. To carry out this replacement, plan ten minutes . But before you start repairs, you will have to make sure that the malfunction must come from the bulb. We will first see how to find out where the malfunction must come from, then how to change the faulty bulb.
The ceiling bulb of your Suzuki Sx4 no longer works: the different origins.
The bulb is defective . This is of course the most common cause. Whatever happens, you will have to disassemble the light unit from your Suzuki Sx4. In order to do this, you will have to follow the steps in the next part. To check it is very easy. When it is a filament bulb, you can visually check that its filament is broken. When on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly using a voltmeter. Remember to take the voltage on the two poles of the connector. An electrical malfunction . This is less common, however it can still happen on a Suzuki Sx4. It is possible that there is a short juice, or that a connector is dirty. In this situation, inspect the tension at both ends. When the electricity does not pass properly, it will be necessary to follow the wiring until the source of the fault is seen. It is also possible that the connectors are dirty. So, we will have to clean them using a specialized product and re-measure the tension.
How to replace the ceiling bulb of your Suzuki Sx4
Now that you have found the source of the fault, you are sure that the malfunction must come from the bulb. We will see how to change the bulb of the ceiling light point by point on a Suzuki Sx4.
- Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
- Remove the connector
- Disassemble the ceiling light to access the bulb
- Remove the bulb and compare it to the new one. Of course, the size and the base must match
- Install the new bulb carefully
- Replace the connectors and the dome following the reverse procedure
You can now switch on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling bulb of your Suzuki Sx4 will work normally. Enjoy the road.