Replacing the headlight bulb of a Toyota Aygo 2 is a super manipulation easy to perform . You don't need to be an excellent mechanic, this repair requires basic tools and no mechanical knowledge. To carry out this replacement, count about 10 minutes . However, before starting the repairs, it is necessary to make sure that the malfunction comes from the bulb. We will first see how to find out where the malfunction comes from, and then how to change the damaged bulb.change-bulb-ceiling-Toyota-Aygo-2

The ceiling light of your Toyota Aygo 2 no longer works: various reasons.

The bulb is defective . This is of course the most common reason. In any case, you will have to remove the light unit from your Toyota Aygo 2. In order to do this, it is necessary to follow the steps in the next paragraph. To check it is super easy. If it's a filament bulb, you can visually check that this filament is broken. If, on the other hand, it is an LED bulb, it is necessary to check that the current flows properly thanks to a voltmeter. Remember to take the voltage on the two poles of the connector. An electrical malfunction . This is less common, however it can still happen on a Toyota Aygo 2. There may be a short circuit, or a connector may be dirty. In this situation, inspect the voltage at both poles. If the current does not flow properly, you must follow the wiring until you can see the source of the fault. It is also possible that the connectors are dirty. In this case, it will be necessary to clean them using a specialized product and re-measure the voltage.

How to replace the ceiling bulb of your Toyota Aygo 2

Now that you have found the source of the fault, you are sure the problem is with the bulb. We will see how to change the bulb of the ceiling light point by point on a Toyota Aygo 2.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Install the new bulb carefully
  • Replace the connectors and the ceiling light in the other direction

You can now switch on the ignition and check that the bulb is working properly. It's good, you're done! The bulb in the ceiling light of your Toyota Aygo 2 will work normally. Good road.