Changing the light bulb in a Toyota Corolla 6 is an extremely simple to execute . You don't have to be an excellent mechanic, it requires few tools and no mechanical knowledge. To perform this operation, count ten minutes . However, before starting the repairs, you will have to make sure that the problem comes from the bulb. We will first find out how to find out where the problem is coming from, then how to change the burnt out bulb.change-bulb-ceiling-Toyota-Corolla-6

The ceiling bulb of your Toyota Corolla 6 no longer works: the different reasons.

The bulb is defective . This is naturally the most common cause. Whatever happens, you will have to remove the light unit from your Toyota Corolla 6. In order to do this, you will have to follow the steps in the next part. To check it is extremely simple. When it is a filament bulb, you can visually check that its filament is broken. When on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly thanks to a voltmeter. Try to take the voltage on the two poles of the connector. An electrical concern . It is less common, but it can still happen on this Toyota Corolla 6. It is possible that there is a bad contact, or that a connector is dirty. In this case, check the voltage at both poles. When the electricity does not pass properly, you will have to follow the electrical cables until you can see the cause of the failure. It is also possible that the connectors are dirty. Then, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the ceiling light bulb on your Toyota Corolla 6

Now that you have found the cause of the failure, you are certain that the problem comes from the bulb. We will see how to change the bulb of the ceiling light step by step on this Toyota Corolla 6.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Dismount the ceiling lamp in order to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must be identical
  • Attach the new bulb carefully
  • Reposition the connectors and the ceiling light in the other direction

You can now switch on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling bulb of your Toyota Corolla 6 will work normally. Enjoy the road.