Replacing the light bulb in a Toyota Corolla 9 Ts is a super manipulation simple to perform . No need to be an excellent mechanic, it requires few tools and no mechanical knowledge. To make this replacement, count ten minutes . However before launching into repairs, you must make sure that the problem comes from the bulb. We will see first how to find out where the problem came from, then how to change the burnt out bulb.change-bulb-ceiling-Toyota-Corolla-9-Ts

The interior lighting of your Toyota Corolla 9 Ts no longer works: the different causes.

The bulb is defective . This is of course the most common reason. Whatever happens, you will need to remove the light block from the Toyota Corolla 9 Ts. To do this, follow the steps in the next paragraph. To control it it's super simple. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, it must be checked that the electricity circulates properly thanks to a voltmeter. Remember to take the voltage on both sides of the connector. An electrical problem . It's less ordinary, however it can still happen on this Toyota Corolla 9 Ts. There may be a short juice, or a connector may be dirty. In this case, examine the voltage at both ends. If the electricity does not pass properly, you must follow the wiring until you find the source of the fault. The connectors may also be dirty. In this case, it will be necessary to clean them using a specialized product and measure the voltage again.

How to replace the ceiling light bulb on your Toyota Corolla 9 Ts

Once you find the source of the failure, you can be sure that the problem is with the bulb. We will see how to change the ceiling light bulb point by point on this Toyota Corolla 9 Ts.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Dismount the ceiling lamp in order to access the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling lamp of your Toyota Corolla 9 Ts will work normally. Good walk.