Replacing the light bulb in a Toyota Crown is a very repair easy to execute . You don't have to be a great mechanic, it requires few tools and no mechanical knowledge. To perform this operation, count about 10 minutes . But before you start the work, it is necessary to make sure that the problem must come from the bulb. We will first see how to find out where the problem is coming from, then how to change the faulty bulb.change-bulb-ceiling-Toyota-Crown

The overhead lighting on your Toyota Crown no longer works: the different origins.

The bulb is defective . This is of course the most common reason. Whatever happens, you will need to remove the light unit from your Toyota Crown. To do this, it is necessary to follow the steps in the following paragraph. To control it is very easy. In case it is a filament bulb, you can visually check that this filament is broken. In the case where it is an LED bulb, it is necessary to check that the electricity circulates properly thanks to a voltmeter. Try to measure the voltage on the two poles of the connector. An electrical problem . It is less common, however it can still happen on this Toyota Crown. There may be a short juice, or a connector may be dirty. In this situation, check the voltage at both poles. In the event that the electricity does not pass properly, the electric wires must be followed until the source of the fault is found. The connectors may also be dirty. So, you will have to clean them with a specialized product and measure the voltage.

How to replace the ceiling light bulb on your Toyota Crown

Once you have found the source of the fault, you are sure that the problem must come from the bulb. We will see how to change the ceiling light bulb point by point on this Toyota Crown.

  • Remove the ceiling light with a flat screwdriver. Pass it in the groove to make a lever.
  • Remove the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the size and the base must be identical
  • Place the new bulb carefully
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The light bulb of your Toyota Crown will work normally. Good walk.