Changing the light bulb in a Toyota Dyna is a very repair easy to execute . No need to be a great handyman, it requires few tools and no knowledge of mechanics. To carry out this replacement, plan ten minutes . But before starting the work, it is necessary to make sure that the malfunction must come from the bulb. We will first see how to know where the malfunction should come from, then how to change the damaged bulb.change-bulb-ceiling-Toyota-Dyna

The ceiling bulb of your Toyota Dyna does not work anymore: the different reasons.

The bulb is defective . This is obviously the most common reason. In all cases, you will have to remove the lighting unit from your Toyota Dyna. To do this, it is necessary to follow the steps in the next paragraph. To control it is very easy. If ever it is a filament bulb, you can visually check that the filament is broken. If on the other hand it is an LED bulb, it is necessary to check that the current flows properly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical malfunction . It is less common, however it can still happen on this Toyota Dyna. There may be a short juice, or a connector may be dirty. In this case, check the voltage at both ends. If the current does not pass properly, you will have to follow the electric wires until you find the cause of the failure. The connectors may also be dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the ceiling light bulb on your Toyota Dyna

Now that you have found the cause of the failure, you are sure that the malfunction must come from the bulb. We will see how to change the bulb of the ceiling light point by point on this Toyota Dyna.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must be identical
  • Attach the new bulb gently
  • Replace the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. It's good, it's done! The ceiling lamp of your Toyota Dyna should work normally. Enjoy the road.