Replacing the light bulb in a Toyota Endo is a super manipulation simple to execute . No need to be a great mechanic, it requires basic tools and no mechanical knowledge. To carry out this replacement, plan about 10 minutes . But before you start repairing, you will have to make sure that the problem must come from the bulb. We will see first of all how to know where the problem must come from, then how to change the faulty bulb.change-bulb-ceiling-Toyota-Endo

The ceiling lights of your Toyota Endo no longer work: the different reasons.

The bulb is defective . This is obviously the most common reason. Whatever happens, you will need to remove the light block from the Toyota Endo. To do this, you will have to follow the steps in the next part. To control it it's super simple. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the current flows properly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical problem . It's less ordinary, however it can still happen on a Toyota Endo. There may be a false contact, or a connector may be dirty. In this case, inspect the voltage at both ends. In case the current does not pass properly, you will have to follow the electric cables until you find the source of the failure. The connectors may also be dirty. In this case, it will be necessary to clean them using a specialized product and measure the voltage.

How to replace the light bulb on your Toyota Endo

Now that you have found the source of the fault, you are sure that the problem must come from the bulb. We will see how to change the bulb of the ceiling light step by step on a Toyota Endo.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Disassemble the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must be identical
  • Carefully place the new bulb
  • Replace the connectors and the ceiling light in reverse order

You can now turn on the ignition and check that the bulb is working properly. And now, voila ! The ceiling lamp of your Toyota Endo will operate normally. Good walk.