Changing the light bulb in a Toyota Ft-hs is an extremely easy to perform . No need to be a great handyman, this repair requires basic tools and no mechanical knowledge. To carry out this operation, plan about 10 minutes . However, before starting the repairs, you will need to make sure that the problem comes from the bulb. We will first see how to find out where the problem is coming from, then how to replace the burnt out bulb.change-bulb-ceiling-toyota-Ft-hs

The overhead lighting on your Toyota Ft-hs no longer works: the different reasons.

The bulb is defective . This is obviously the most common cause. Whatever happens, you will have to remove the lighting unit from your Toyota Ft-hs. To do this, you will need to follow the steps in the next section. To control it is extremely easy. If it is a filament bulb, you can visually check that its filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly by using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical problem . It's less common, however it can still happen on a Toyota Ft-hs. It is possible that there is a short-juice, or that a connector is dirty. In this case, check the tension at both ends. If the electricity does not pass properly, you must follow the wiring until you find the cause of the failure. It is also possible that the connectors are dirty. Then, it will be necessary to clean them thanks to a specialized product and to measure the tension again.

How to replace the ceiling light bulb on your Toyota Ft-hs

Now that you have found the cause of the failure, you are sure that the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on a Toyota Ft-hs.

  • Remove the ceiling lamp using a flat screwdriver. Insert it into the groove to pry.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must be identical
  • Place the new bulb carefully
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling lamp of your Toyota Ft-hs should work normally. Good walk.