Changing the bulb of the ceiling light of a Toyota Hi Ace 3 is an extremely easy to make . You don't need to be an excellent mechanic, it requires few tools and no mechanical knowledge. To carry out this replacement, count about 10 minutes . But before you start the work, you will need to make sure that the problem must be with the bulb. We will first of all see how to find out where the problem must come from, and then how to change the burnt out bulb.change-bulb-Toyota-Hi-Ace-3

The ceiling light of your Toyota Hi Ace 3 no longer works: the different origins.

The bulb is defective . This is of course the most common cause. In any case, you will have to disassemble the light unit from your Toyota Hi Ace 3. In order to do this, you will have to follow the steps in the following paragraph. To verify it is extremely easy. When it is a filament bulb, you can visually check that its filament is broken. When on the other hand it is an LED bulb, you will have to check that the current flows correctly by using a voltmeter. Try to measure the voltage on the two poles of the connector. An electrical problem . This is less common, however it can still happen on a Toyota Hi Ace 3. There may be a short circuit, or a connector may be dirty. In this situation, check the voltage at both ends. When the current is not flowing properly, you must follow the electrical cables until you can see the cause of the failure. The connectors may also be dirty. So, you will have to clean them with a specialized product and measure the voltage again.

How to replace the ceiling bulb of your Toyota Hi Ace 3

Once you have found the cause of the failure, you are sure that the problem must come from the bulb. We will see how to change the bulb of the ceiling light point by point on a Toyota Hi Ace 3.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light in order to have access to the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must be identical
  • Attach the new bulb carefully
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling bulb of your Toyota Hi Ace 3 will work normally. Good road.