Changing the ceiling light bulb on a Toyota Land Cruiser Sw Serie 60 is an extremely easy to perform . No need to be an excellent mechanic, it requires few tools and no mechanical knowledge. To make this replacement, plan about 10 minutes . However before starting the work, you will have to make sure that the problem must come from the bulb. We will see first how to know where the problem should come from, then how to change the failed bulb.change-bulb-ceiling-Toyota-Land-Cruiser-Sw-Serie-60

The interior lighting of your Toyota Land Cruiser Sw Serie 60 no longer works: the different causes.

The bulb is defective . This is naturally the most common cause. In all cases, you will have to dismantle the light block of the Toyota Land Cruiser Sw Serie 60. To do this, you will have to follow the steps in the next section. To verify it is extremely easy. If it is ever a filament bulb, you can visually check that its filament is broken. If on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates correctly using a voltmeter. Remember to measure the voltage on the two poles of the connector. An electrical concern . It's less ordinary, but it can still happen on this Toyota Land Cruiser Sw Serie 60. It is possible that there is a false contact, or that a connector is dirty. In this situation, examine the tension at both ends. If the electricity does not pass correctly, you must follow the electric wires until you find the cause of the failure. It is also possible that the connectors are dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the light bulb on your Toyota Land Cruiser Sw Serie 60

Once you have found the cause of the failure, you are certain that the problem must come from the bulb. We will see how to change the bulb of the ceiling light step by step on this Toyota Land Cruiser Sw Serie 60.

  • Remove the ceiling lamp with a flat screwdriver. Introduce it into the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must be identical
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb works properly. And voila, it's done! The light bulb of your Toyota Land Cruiser Sw Serie 60 will work normally. Good road.