Replace the light bulb in a Toyota Mr 2 is an extremely manipulation simple to perform . No need to be an excellent handyman, it requires basic tools and no mechanical knowledge. To carry out this replacement, count ten minutes . However, before starting the work, you must make sure that the problem comes from the bulb. We will first see how to find out where the problem comes from, then how to replace the defective bulb.change-bulb-ceiling-Toyota-Mr-2

The overhead lighting on your Toyota Mr 2 no longer works: the different origins.

The bulb is defective . This is of course the most common cause. Whatever happens, you will have to remove the lighting unit from the Toyota Mr 2. To do this, you will have to follow the steps in the next section. To verify it is extremely simple. When it is a filament bulb, you can visually check that the filament is broken. When, on the other hand, it is an LED bulb, it will be necessary to check that the current flows properly thanks to a voltmeter. Try to measure the voltage on the two poles of the connector. An electrical concern . It is less common, however it can still happen on a Toyota Mr 2. It happens that there is a short circuit, or that a connector is dirty. In this situation, check the voltage at both ends. When the current does not flow properly, you must follow the wiring until you find the source of the failure. It also happens that the connectors are dirty. In this case, it will be necessary to clean them using a specialized product and measure the voltage again.

How to replace the ceiling light bulb on your Toyota Mr 2

Once you have found the source of the failure, you are sure that the concern comes from the bulb. We will see how to replace the ceiling light bulb point by point on a Toyota Mr 2.

  • Remove the ceiling lamp using a flat screwdriver. Introduce it into the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the size and the base must match
  • Install the new bulb carefully
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. It's good, voila! The ceiling lamp of your Toyota Mr 2 should work normally. Good road.