Changing the light bulb in a Toyota Paseo is a super manipulation easy to execute . No need to be a great mechanic, this repair requires few tools and no mechanical knowledge. To perform this operation, count ten minutes . But before starting the repairs, you will have to make sure that the problem comes from the bulb. We will first see how to know where the problem comes from, then how to change the burnt out bulb.
The ceiling bulb of your Toyota Paseo does not work anymore: the different causes.
The bulb is defective . This is obviously the most common reason. Whatever happens, you will have to remove the light unit from the Toyota Paseo. To do this, you will need to follow the steps in the next section. To verify it is super easy. In case it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, you must check that the current flows correctly using a voltmeter. Try to measure the voltage on the two poles of the connector. An electrical concern . It's less ordinary, however it can still happen on a Toyota Paseo. There may be a short circuit, or a connector may be dirty. In this case, check the voltage at both poles. In the event that the current does not flow correctly, you must follow the wiring until you find the source of the failure. The connectors may also be dirty. In this case, you will have to clean them with a specialized product and measure the tension again.
How to replace the light bulb on your Toyota Paseo
Once you have found the cause of the failure, you are certain that the problem comes from the bulb. Let's see how to change the ceiling light bulb point by point on a Toyota Paseo.
- Remove the ceiling light using a flat screwdriver. Insert it into the groove to pry.
- Disconnect the connector
- Disassemble the ceiling light to access the bulb
- Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must match
- Install the new bulb carefully
- Replace the connectors and the dome following the reverse procedure
You can now switch on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling lamp of your Toyota Paseo should work normally. Good road.