Changing the light bulb of a Toyota Rav 4 (4th Generation) ceiling light is a super operation easy to perform . No need to be a great handyman, this repair requires basic tools and no mechanical knowledge. To make this replacement, plan about 10 minutes . However before starting the repairs, it is necessary to make sure that the problem originated from the bulb. We will first find out how to find out where the problem came from, and then how to replace the faulty bulb.change-bulb-dome light-Toyota-Rav-4- (4rd-Generation)

The interior lighting of your Toyota Rav 4 (4th Generation) does not work anymore: the different causes.

The bulb is defective . This is obviously the most common cause. Whatever happens, you will have to remove the lighting unit from your Toyota Rav 4 (4th Generation). To do this, it is necessary to follow the steps in the following paragraph. To control it is super easy. If ever it is a filament bulb, you can visually check that the filament is broken. If on the other hand it is an LED bulb, it is necessary to check that the current flows properly using a voltmeter. Try to measure the voltage on both sides of the connector. An electrical problem . It's less ordinary, however it can still happen on this Toyota Rav 4 (4th Generation). There may be a false contact, or a connector may be dirty. In this case, check the voltage at both ends. If the current does not pass properly, you will have to follow the wiring until you see the cause of the failure. The connectors may also be dirty. So, we will have to clean them with a specialized product and measure the voltage again.

How to replace the light bulb on your Toyota Rav 4 (4th Generation)

Once you have found the cause of the failure, you are certain that the problem originated from the bulb. We will see how to replace the light bulb step by step on this Toyota Rav 4 (4rd Generation).

  • Remove the ceiling light using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light in order to have access to the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must be identical
  • Attach the new bulb carefully
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb is working properly. It's good, it's done! The ceiling bulb of your Toyota Rav 4 (4th Generation) should work normally. Good walk.