Changing the light bulb in a Toyota Verso-s is a very manipulation easy to perform . No need to be an excellent handyman, it requires basic tools and no mechanical knowledge. To make this replacement, plan about 10 minutes . However before embarking on repairs, it is necessary to make sure that the malfunction comes from the bulb. We will see first of all how to know where the malfunction comes from, then how to change the burnt out bulb.change-bulb-ceiling-Toyota-Verso-s

The ceiling bulb of your Toyota Verso-s does not work anymore: the different causes.

The bulb is defective . This is obviously the most common reason. In all cases, you will need to remove the lighting unit from your Toyota Verso-s. To do this, it is necessary to follow the steps in the next section. To control it is very easy. If it is a filament bulb, you can visually check that the filament is broken. If, on the other hand, it is an LED bulb, it is necessary to check that the electricity flows correctly using a voltmeter. Remember to measure the voltage on the two poles of the connector. An electrical malfunction . It's less common, but it can still happen on a Toyota Verso-s. There may be a short circuit, or a connector may be dirty. In this case, check the voltage at both poles. If the electricity does not pass correctly, you will have to follow the electric cables until you see the cause of the failure. The connectors may also be dirty. Then, it will be necessary to clean them thanks to a specialized product and to measure the voltage.

How to replace the ceiling light bulb on your Toyota Verso-s

Now that you have found the cause of the failure, you are sure that the malfunction comes from the bulb. Let's see how to change the ceiling light bulb step by step on a Toyota Verso-s.

  • Remove the ceiling light using a flat screwdriver. Introduce it into the groove to make a lever.
  • Remove the connector
  • Dismount the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Obviously, the size and the base must match
  • Place the new bulb carefully
  • Replace the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling lamp of your Toyota Verso-s should work normally. Good walk.