Whether it's about the low beams, high beams or turn signals, the bulb replacement is a super manipulation easy to execute . But if a fire never works, you should not wait to change it. Because some people forget it, but it is punishable by a sanction which can go up to 68 euros. Obviously, it is necessary first to repair them for safety reasons. So that's how to replace the headlight bulb on the Jeep Commander, step by step. Thereafter, we will find out how to properly settle them.
How to change the bulb of a Jeep Commander headlight
Now there are a number of types of headlight bulbs. The most common are halogen , however there are also Xenon , slightly put on the side now, and lots of bulbs LED . They consume much less electricity and are more robust. Whatever kind of bulb, the way to change them will be similar. You will find below the procedure to follow in order to replace the bulb of your Jeep Commander .
- Disconnect the battery to work more comfortably.
- Clear access to the rear portion of the light. It will be necessary from time to time to remove the battery, or covers.
- Remove the rubber or plastic cover on the back of the fire
- Remove the fastener or unscrew the damaged bulb from the Jeep Commander
- Compare it with the new one to be sure it fits
- Place the new bulb gently, then fix it properly
- Replace the rubber cover then all the elements in reverse order
Now that everything is in place, check that it works! This one should have an intensity equal to the other. It is essential to have completely identical models.
Adjusting the headlights of a Jeep Commander
After replacing a light, it remains plausible that it will be out of order. It is extremely important that two lights at the same height and in the same axis. Among other things so as not to annoy motorists opposite. They should therefore be adjusted properly. To do this, you must place your car facing a wall. First a short distance, then a few meters. Then, you just have to adjust the light in question at the same height as the other by comparing the halos. If neither goes, there are tutorials that can help.