That it concerns low beam, high beams or turn signals, the bulb replacement is a super manipulation easy to perform . But in the event that a fire no longer works, it should not be long to replace it. Because many do not know, but it is punishable by a fine of up to 68 euros. Obviously, you will first have to change them for safety reasons. Here is how to change the bulb of a headlight on your Jeep Ford, step by step. Second, we will find out how to properly adjust them.
How to Change the Bulb of a Jeep Ford Headlight
Now there are a number of types of headlight bulbs. The most common are halogen , but we can also find Xenon , a little put on the side today, and more and more bulbs LED . These are much less greedy in electricity and more enduring. Whatever the type of bulb, the way to change them will be similar. So that's the logic to follow for change the bulb of your Jeep Ford .
- Disconnect the battery so that you can work more serenely.
- Clear access to the rear part of the light. It will sometimes be necessary to remove the battery, or else covers.
- Remove the rubber or plastic cover on the back of the light
- Remove the fixing or unscrew the defective bulb from your Jeep Ford
- Compare it with the new one to make sure it fits
- Position the new bulb gently, then fix it properly
- Replace the rubber cover then all the elements in reverse
Now that everything is in place, test the bulb! This should display an intensity similar to the other. It is essential to have perfectly identical models.
How to properly configure the headlights of a Jeep Ford
Now that the fire is in place, it is plausible that it is out of order. It is very important that two lights at the same height and focused the same way. In particular not to annoy motorists opposite. So take the time to settle them properly. To do this, you must place your vehicle in front of a wall. First a meter from the wall, then 5 or 6 meters. Second, you just have to adjust the fire with the new bulb at the same height as the other by comparing the halos. If the two are wrong, there are tutorials that can help.