Whether it's about the low beams, high beams or turn signals, the bulb replacement is a super operation easy to perform . But if a fire no longer works, we must not delay in repairing it. Because some people ignore it, but this remains punishable by a sanction of up to 68 euros. Of course, they must first of all be replaced for safety reasons. So here is how to change the bulb of a headlight on a Jeep Wagoneer, point by point. Next, we will see how to properly adjust them.change-headlight-bulb-Jeep-Wagoneer

How to change the bulb of a Jeep Wagoneer headlight

Now there are various types of headlight bulbs. The most common are halogen , however there are also Xenon , a little put on the side now, and a lot of bulbs LED . These are less energy intensive and more resistant. Regardless of the type of bulb, the way to change them will be similar. Here is the logic to follow for change the bulb of your Jeep Wagoneer .

  • Disconnect the battery so that you can work more comfortably.
  • Clear access to the rear part of the light. Sometimes it will be necessary to remove the battery, or else covers.
  • Remove the rubber or plastic cover behind the fire
  • Unclip or unscrew the broken bulb from your Jeep Wagoneer
  • Compare it with the news to make sure it is suitable
  • Position the new bulb gently, then fix it correctly
  • Replace the rubber cover then all the components following the reverse procedure

Once everything is in place, test the bulb! This one should have the same intensity as the other. It's important to have perfectly similar models.

Correctly adjusting the headlights of a Jeep Wagoneer

Now that the fire is in place, it is plausible that the latter is out of order. It is very important that two lights at the same height and in the same axis. Among other things, so as not to interfere with the drivers you meet. They should therefore be adjusted correctly. To do this, you just have to place your vehicle in front of a wall. First a short distance, then a few meters. Then, you just have to adjust the fire in question to the same height as the other by comparing the halos. If the two are badly adjusted, there are tutorials that can help you.