Whether it's about the low beams, high beams or turn signals, the changing a light bulb is an extremely manipulation simple to make . But when a fire stops working, it should not be long before replacing it. Because many do not know it, but that remains reprehensible by a fine which can go up to 68 euros. Obviously, they must first be changed for safety reasons. Here is how to replace the headlight bulb on a Jeep Willys, step by step. In a second step, we will see how to properly adjust them.
How to Change the Bulb of a Jeep Willys Lighthouse
Today there are various types of headlight bulbs. The most common are halogen , but there are also Xenon , slightly put on the side now, and more and more bulbs LED . These are less energy consuming and more resistant. Regardless of the type of bulb, the way to change them will be similar. So here is the logic to follow in order to replace the bulb in your Jeep Willys .
- Disconnect the battery in order to work more quietly.
- Free access to the rear portion of the fire. Sometimes it will be necessary to remove the battery, or else covers.
- Remove the rubber or plastic cover behind the fire
- Unclip or unscrew the broken bulb of your Jeep Willys
- Compare it well with the new one to make sure it matches
- Place the new bulb gently, then fix it properly
- Replace the rubber cover then all the components in the opposite direction
Now that everything is in order, test the bulb! This should have an intensity similar to the other. It is essential to have perfectly similar products.
How to set the headlights of a Willys Jeep
After replacing a light, it is still possible that it will be out of order. It is extremely important that two lights at the same height and focused the same way. In particular not to disturb the drivers you meet. That is why they must be settled properly. To do this, you just have to position your car in front of a wall. First a meter from the wall, then 5 or 6 meters. In a second step, it is enough to adjust the fire with the new bulb at the same height as the other by comparing the halos. If neither goes, there are tutorials very well on this subject.