Whether it's about the low beams, high beams or turn signals, the bulb replacement is an extremely convenient to perform . But if ever a fire does not work, do not wait to replace it. Because some people are unaware of it, but it is condemnable by a fine which can go up to 68 euros. Obviously, you will have to repair them first for safety reasons. So here is how to change the headlight bulb on a Kia Cee D 2 Sw, step by step. Subsequently, we will see how to properly adjust them.change-headlight-bulb-Kia-Cee-D-2-Sw

How to replace the bulb of a Kia Cee D 2 Sw headlight

Now there are a number of types of headlight bulbs. The most common are halogen , however there are also Xenon , somewhat put on the side now, and more and more bulbs LED . These are much less energy intensive and more robust. Regardless of the type of bulb, the way to replace them will be similar. Below is the logic to follow for change the bulb of your Kia Cee D 2 Sw .

  • Disconnect the battery to work more comfortably.
  • Free access to the rear part of the light. It will sometimes be necessary to remove the battery, or covers.
  • Remove the rubber or plastic cover behind the fire
  • Remove the fixing or unscrew the damaged bulb from the Kia Cee D 2 Sw
  • Compare it well with the new one to make sure it fits
  • Position the new bulb gently, then fix it correctly
  • Replace the rubber cover then all the elements in reverse order

Once everything is back in order, check that it works! The latter should have the same intensity as the other. It is essential to have perfectly similar models.

How to configure the headlights of a Kia Cee D 2 Sw

After replacing a light, it is plausible that it will be out of order. It is extremely important that two lights at the same height and focused in the same way. In particular so as not to disturb the motorists that you pass. It is therefore advisable to take the time to adjust them correctly. To do this, you have to place your car facing a wall. To start at a short distance, then to 5 or 6 meters. Subsequently, you just have to adjust the fire in question to the same height as the other by comparing the halos. If neither of the two works, there are some very well-made tutorials on the subject.