That it concerns low beam, high beams or turn signals, the bulb replacement is a very repair easy to do . But when a fire does not work, it should not be long to change it. Because many forget it, but it is punishable by a fine of up to 68 euros. Obviously, you will have to start repairing them for safety reasons. Here is how to change the bulb of a headlight on your Seat Altea Freetrack, step by step. Then we will see how to properly adjust them.change-bulb-headlight-Seat-Altea-Freetrack

How to replace the bulb in a Seat Altea Freetrack headlight

Nowadays, there are several types of headlight bulbs. The most common are halogen , however there are also Xenon , slightly put on the side now, and more and more bulbs LED . These are less energy intensive and more enduring. Regardless of the type of bulb, the way to replace them will be similar. You will find below the logic to follow in order to change the bulb in your Seat Altea Freetrack .

  • Disconnect the battery in order to work more serenely.
  • Clear access to the rear part of the light. It will sometimes be necessary to remove the battery, or covers.
  • Remove the rubber or plastic cover behind the fire
  • Remove the fixing or unscrew the broken bulb from the Seat Altea Freetrack
  • Compare it with the news to make sure it matches
  • Position the new bulb gently, then fix it properly
  • Replace the rubber cover then all the elements in the other direction

Now that everything is in place, check that it works! This should display an intensity similar to the other. It is essential to have perfectly identical models.

How to set the headlights of a Seat Altea Freetrack

After replacing a light, it remains plausible that it will be out of order. It is extremely important that two lights at the same height and focused the same way. Among other things so as not to annoy the drivers you meet. That is why we must take the time to settle them properly. To do this, you just have to position your car facing a wall. To start a short distance, then a few meters. Then just set the light in question to the same height as the other by comparing the halos. If the two are incorrectly adjusted, there are tutorials that can help you.