That it concerns low beam, high beams or turn signals, the bulb replacement is an extremely repair simple to execute . But if a fire does not work, do not wait to change it. Because many ignore it, but it remains reprehensible with a fine of up to 68 euros. Obviously, it is necessary to replace them for safety reasons first. Here is therefore how to change the headlight bulb on a Toyota Camry 2, point by point. Second, we will find out how to properly fix them.
How to replace the bulb of a Toyota Camry 2 headlight
Nowadays, there are various types of headlight bulbs. The most common are halogen , however there are also Xenon , slightly put on the side now, and more and more bulbs LED . They consume much less electricity and are more enduring. Whatever the type of bulb, the way to replace them will be identical. So here is the procedure to follow for change the bulb in your Toyota Camry 2 .
- Disconnect the battery to work more comfortably.
- Clear access to the rear part of the light. It will be necessary from time to time to remove the battery, or covers.
- Remove the rubber or plastic cover behind the fire
- Unclip or unscrew the damaged bulb from your Toyota Camry 2
- Compare it well with the new one to make sure it fits
- Position the new bulb gently, then fix it properly
- Replace the rubber cover and all the components in the opposite direction
Now that everything is in place, test the bulb! This one should have the same intensity as the other. It is important to have perfectly similar models.
How to properly configure the headlights of a Toyota Camry 2
Now that the fire is in place, it is plausible that it is out of order. It is extremely important that two lights at the same height and focused the same way. Especially so as not to hinder motorists opposite. So take the time to settle them properly. To do this, you must place your automobile in front of a wall. First a meter from the wall, then 5 or 6 meters. Second, just set the fire with the new bulb in the same way as the other by comparing the halos. If the two are poorly adjusted, there are tutorials very well done on this subject.