Whether it's for low beam, high beams or turn signals, the bulb replacement is a very repair convenient to do . But if a fire does not work, you should not delay in changing it. Because many forget it, but this is condemnable by a fine which can go up to 68 euros. Obviously, it will be necessary above all to change them for security reasons. Here is how to replace the bulb of a headlight on the Toyota Ft-86 (2), step by step. Second, we will find out how to properly fix them.change-bulb-headlight-Toyota-Ft-86- (2)

How to replace the bulb of a Toyota Ft-86 headlight (2)

Now there are various types of headlight bulbs. The most common are halogen , however there are also Xenon , a little put on the side today, and a lot of bulbs LED . These are less energy consuming and more robust. Regardless of the type of bulb, the way to replace them will be similar. You will find below the logic to follow in order to replace the bulb in your Toyota Ft-86 (2) .

  • Disconnect the battery to work more comfortably.
  • Clear access to the rear portion of the light. From time to time it will be necessary to remove the battery, or else covers.
  • Remove the rubber or plastic cover on the back of the light
  • Remove the fixing or unscrew the defective bulb from the Toyota Ft-86 (2)
  • Compare it well with the new one to be sure it matches
  • Place the new bulb gently, then fix it properly
  • Replace the rubber cover and all components in the opposite direction

Now that everything is in place, check that it works! The latter should have an intensity similar to the other. It is important to have perfectly similar products.

How to adjust the headlights of a Toyota Ft-86 (2)

After replacing a light, it is plausible that it will be out of order. It is very important that two lights at the same height and in the same axis. Among other things so as not to annoy motorists in the other direction. They must therefore be settled properly. To do this, simply place your automobile facing a wall. First a short distance, then 5 or 6 meters. Second, just set the fire with the new bulb in the same way as the other by comparing the halos. If neither goes, there are very good tutorials on this.