Whether it's for low beam, high beams or turn signals, the bulb replacement is a super repair simple to do . But when a fire no longer works, you should not wait to change it. Because some people forget it, but it is condemnable by a ticket which can go up to 68 euros. Obviously, they must first be repaired for safety reasons. Here is how you can replace the headlight bulb on your Toyota Highlander 2, step by step. Next, we will see how to properly adjust them.
How to change the bulb of a Toyota Highlander 2 headlight
Nowadays, there are various types of headlight bulbs. The most common are halogen , however there are also Xenon , a little neglected now, and more and more bulbs LED . These are much less energy consuming and more resistant. Regardless of the type of bulb, the way to change them will be similar. So here is the logic to follow in order to replace the bulb in your Toyota Highlander 2 .
- Disconnect the battery in order to work more quietly.
- Clear access to the rear portion of the light. Sometimes it will be necessary to remove the battery, or else covers.
- Remove the rubber or plastic cover behind the fire
- Unclip or unscrew the broken bulb of the Toyota Highlander 2
- Compare it well with the new one to make sure it matches
- Put the new bulb down gently, then fix it properly
- Replace the rubber cover and all the elements in reverse order
Now that everything is in order, test the bulb! The latter should have an intensity equal to the other. It is essential to have perfectly identical products.
How to set the headlights of a Toyota Highlander 2
After replacing a light, it is possible that it will be out of order. It is very important that two lights at the same height and focused the same way. Among other things so as not to annoy motorists in the other direction. That is why they must be settled properly. To do this, you just have to position your automobile facing a wall. First one meter from the wall, then 5 or 6 meters. Then, you just have to adjust the light in question at the same height as the other by comparing the halos. If neither goes, there are very good tutorials on this.