Whether it's for low beam, high beams or turn signals, the changing a light bulb is a very operation easy to execute . But when a fire does not work, it should not be long to repair it. Because some people ignore it, but it is condemnable by a fine of up to 68 euros. Of course, you will have to replace them first for safety reasons. Here is therefore how to change the bulb of a headlight on a Toyota Mr 3, step by step. Second, we will find out how to properly fix them.
How to change the bulb of a Toyota Mr 3 headlight
Now there are a number of types of headlight bulbs. The most common are halogen , however there are also Xenon , slightly neglected now, and lots of bulbs LED . These are much less energy intensive and more resistant. Whatever kind of bulb, the way to change them will be similar. So here is the logic to follow in order to change the bulb of your Toyota Mr 3 .
- Disconnect the battery so that you can work more quietly.
- Clear access to the rear part of the light. Sometimes it will be necessary to disassemble the battery, or else covers.
- Remove the rubber or plastic cover behind the fire
- Remove the fixing or unscrew the defective bulb from your Toyota Mr 3
- Compare it with the news to make sure it fits
- Put the new bulb down gently, then fix it properly
- Replace the rubber cover and all of the components, following the reverse procedure
Once everything is in order, check that it works! The latter should display an intensity similar to the other. It is essential to have perfectly identical products.
How to set the headlights of a Toyota Mr 3
Now that the fire is in place, it is plausible that it is out of order. It is extremely important that two lights at the same height and in the same axis. Among other things so as not to disturb the drivers you meet. They must therefore be settled properly. To do this, you must position your vehicle in front of a wall. To start one meter from the wall, then 5 or 6 meters. Second, you just have to adjust the fire with the new bulb at the same height as the other by comparing the halos. If the two are poorly adjusted, there are tutorials very well done on this subject.