Whether it's for low beam, high beams or turn signals, the changing a light bulb is an extremely manipulation simple to perform . But when a fire no longer works, it should not be long to repair it. Because many ignore it, but it remains reprehensible with a fine of up to 68 euros. Obviously, they will first have to be repaired for safety reasons. So that's how to replace the headlight bulb on your Toyota Rav 4 (2nd Generation), point by point. In the second step, we will find out how to set them correctly.
How to change the bulb of a Toyota Rav 4 (2nd Generation) headlight
Today, there are several types of headlight bulbs. The most common are halogen , but we can also find Xenon , somewhat put on the side now, and lots of bulbs LED . These are much less power hungry and more robust. No matter what kind of bulb, the way to change them will be similar. So here is the procedure to follow for replace the bulb in your Toyota Rav 4 (2nd Generation) .
- Disconnect the battery so that you can work more quietly.
- Clear access to the rear portion of the light. Sometimes it will be necessary to disassemble the battery, or else covers.
- Remove the rubber or plastic cover behind the fire
- Unclip or unscrew the damaged bulb of your Toyota Rav 4 (2nd Generation)
- Compare it well with the new one to be certain that it is suitable
- Place the new bulb gently, then fix it correctly
- Replace the rubber cover and all the elements following the reverse procedure
Once everything is in place, check that it works! This one should have the same intensity as the other. It is important to have perfectly similar models.
Adjust the headlights of a Toyota Rav 4 (2nd Generation)
After replacing a light, it is possible that it will be out of order. It is extremely important that two lights at the same height and in the same axis. Among other things so as not to annoy the motorists you meet. They must therefore be set correctly. To do this, you must place your automobile facing a wall. First one meter from the wall, then 5 or 6 meters. In a second step, it suffices to adjust the light in question to the same height as the other by comparing the halos. If neither goes, there are very good tutorials on this.