The advantage of an electric window regulator is undeniable compared to manual systems. On the other hand, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not necessarily easy to precisely determine the source of the failure. In this article we will see how to change the electric window of a Citroen Tubik . But before you start, you need to be sure you understand where the fault is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes work. Whether it's a false contact, or quite simply a lack of oiling. Now that you've identified the source of the concern, let's get to the heart of the matter.
How to replace a Citroen Tubik window regulator
Replacing a window regulator is quite time consuming. Depending on your experience in the field, count approximately three hours in order to be sure to have the necessary time. Whether for a Citroen Tubik or on another car, this operation is for experienced handymen. So let's see how to do it, point by point. We recommend that you take a picture at different times in order to help you reassemble the new window regulator.
Removing a window regulator on a Citroen Tubik
- Remove the entire door trim. From mirror cover to handle. This operation should be done carefully enough using a flat screwdriver. You will have to make sure you can access the window regulator at all points without being disturbed. This manipulation is the longest to perform.
- Remove the window regulator seals from your Citroen Tubik. Again, it's wiser to go about it carefully.
- Now that you have access to the window regulator, disconnect the connectors. You can then release the window regulator motor if it is stuck.
- Remove all of the fasteners that hold the glass, then remove the glass. It is sometimes preferable to position the window halfway up to perform this operation. Of course you have to be very careful when handling the glass. It is best to put it on a rather thick sheet.
- Remove the window regulator completely. It is wiser to memorize its location well. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, so they must be removed.
The installation of an electric window of a Citroen Tubik
- Position the new window regulator. Make sure that its location is similar to the damaged window regulator. You will no doubt need to use the fasteners that you have removed.
- Reposition the glass as you took it out. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
- Reconnect the connectors.
- Fit the seals you removed.
- Replace all of the door trim.
It's done, you now have a new and functional window regulator . So you can put the ignition on and test it.