The advantage of an electric window regulator is enormous in comparison with manual systems. However, it has the defect of being much more restrictive in terms of repairs. Also, it is not always easy to identify precisely the source of the problem. Here we will see how to change the electric window regulator of a Hyundai I-blue . But before you start, you need to be sure you understand where the problem is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair can often suffice. Whether it's an electrical short, or just a lack of lubrication. Now that you are sure of the source of the problem, let's get to the heart of the matter.
How to replace a Hyundai I-blue window regulator
Changing a window regulator is rather tedious. Depending on your experience on the subject, plan approximately two o'clock to make sure you don't get caught up in time. Whether it's for a Hyundai I-blue or another vehicle, this repair is for experienced DIY enthusiasts. So let's look at how to do it, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai I-blue
- Remove the entire door trim. From the handle to the mirror cover. This should be done very gently with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being disturbed. This step is the longest to complete.
- Disassemble the window regulator seals from your Hyundai I-blue. Again, it is wiser to do it carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You will then have to release the window lifter motor when it is blocked.
- Take out all the fasteners that hold the glass, then release it. It is sometimes better to place the window halfway up to carry out this operation. Of course you have to be very careful when handling the glass. It is advisable to put it on a sufficiently thick sheet.
- Disassemble the window regulator as a whole. It is wiser to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, it is therefore necessary to remove them.
The installation of an electric window regulator of a Hyundai I-blue
- Position the new window regulator. Make sure that its position is similar to the previous window regulator. You should definitely use the bindings you have set aside.
- Replace the glass just as you removed it. It will sometimes be necessary to move it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Fit the seals that you have carefully removed.
- Refit the entire door trim.
It's good, you now have a new and working window regulator . You will therefore have to switch on and test it.