The advantage of an electric window regulator is enormous compared to manual systems. However, it has the defect of being much more restrictive in terms of repairs. In addition, it is not necessarily easy to determine precisely the nature of the problem. In this article, we will see how to replace the electric window regulator of a Hyundai I-mode . But before you start, you have to be sure you understand where the problem came from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple small repair can often work. Whether it's a short circuit, or just a lack of lubrication. Now that you're sure of the cause, let's get to the heart of the matter.change-window-lift-Hyundai-I-mode

How to replace a Hyundai I-mode window regulator

Changing a window regulator is rather tedious. Depending on your experience in the field, count approximately three hours to make sure you don't get caught up in time. Whether it is for a Hyundai I-mode or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. It is advisable to take pictures at different times to help you install the new window regulator.

Removing a window regulator on a Hyundai I-mode

  • Remove all of the door trim. From the handle to the mirror cover. This should be done very gently using a flat screwdriver. You will have to make sure to access the window regulator at any point without being disturbed. This step is quite long to perform.
  • Remove the window regulator seals from your Hyundai I-mode. Again, it is crucial to do this carefully.
  • Now that you have access to the window regulator, remove the connectors. You will then have to remove the motor from the window regulator if it is ever stuck.
  • Release all the fasteners that hold the window, then release it. It is occasionally advisable to place the window halfway up to carry out this operation. Of course you will have to be very careful when moving the window. It is best to put it on a rather thick sheet.
  • Remove the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is occasionally held in place by screws or rivets, so you will need to remove them.

Installation of an electric window regulator in a Hyundai I-mode

  • Introduce the new window regulator. Make sure that its position is similar to the previous window lifter. You will probably have to use the fasteners that you have put aside.
  • Replace the glass in the same way as you removed it. It will be necessary from time to time to make it move a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals you removed.
  • Replace all of the door trim.

It's done, you now have a new and functional window regulator . So you will need to turn on your car and test it.