The advantage of an electric window regulator is undeniable compared to manual mechanisms. On the other hand, it has the defect of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the problem. In this article we will see how to repair the electric window regulator of a hyundai i10 . But before you start, you need to be sure you understand where the problem is coming from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes work. Whether it concerns an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the malfunction, let's get to the heart of the matter.
Replacing a window regulator for hyundai i10: how to do it
Changing a window regulator is rather time-consuming. Depending on your experience on the subject, count about two o'clock to make sure you have the time you need. Whether for a Hyundai i10 or another vehicle, this manipulation is for experienced DIY enthusiasts. So let's take a look at what to do, step by step. It is advisable to take photos at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai i10
- Remove the entire door trim. From the mirror cover to the handle. This should rather be done with care with a flat screwdriver. You will have to make sure to access the window regulator at any point without being disturbed. This step is the longest to perform.
- Remove the window regulator seals from your hyundai i10. Again, it is essential to take it delicately.
- Now that you have accessed the window regulator, remove the connectors. You will then have to disengage the window lifter motor when it is stuck.
- Remove all the fasteners that hold the glass, then remove the glass. It is sometimes advisable to position the window halfway up to carry out this manipulation. Naturally, great care must be taken when handling the glass. It is advisable to place it on a rather thick sheet.
- Remove the window regulator entirely. It is essential to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is at times held by screws or rivets, so they must be removed.
The installation of an electric window regulator of a hyundai i10
- Fit the new window regulator. Make sure that its position is identical to the damaged window lifter. You will certainly need to use the bindings you have set aside.
- Reposition the glass as you removed it. At times it will be necessary to rotate it slightly so that it fits correctly in its guide.
- Reconnect the connectors.
- Replace the seals that you have carefully removed.
- Replace the door trim assembly.
It's good, you now have a new and functional window regulator . You will therefore have to switch on and test it.